Hours will feel like minutes with this pattern to make the cute TVA mascot "Miss Minutes" from the new Loki series. We are going to need: cotton yarn orange 10 g, white and black 5 g, white and black felt/ eva foam and embroidery floss. The finished doll will be 8 cm / 3,1 inches tall.
If you want a pdf version of this pattern you can find it in my Etsy shop: https://hisheepok.etsy.com/listing/1046834633/miss-minutes-tva-crochet-pattern
mr: magic ring
sl st: slip stitch
sc: single crochet
LEGS:
Make two.
With white.
R1: 7 sc in mr
R2: 7 sc back loop only [7]
R3: 7 sc [7]
Change color to black.
R4: sc dec, 5 sc [6]
R5-7: 6 sc [6]
R8: 5 sc, 1 sl st [6]
Break yarn leaving enough for sewing.
ARMS:
Make two.
With white.
R1: 6 sc in mr
R2: 6 sc [6]
Change to orange.
R3-7: 6 sc [6]
Break yarn leaving enough for sewing.
Make two.
With white.
R1: 6 sc in mr
R2: 6 sc [6]
Change to orange.
R3-7: 6 sc [6]
Break yarn leaving enough for sewing.
BODY:
NOTE: I'd recommend stopping at R11, sew on pieces and then finish the body.
With orange.
R1: 6 sc in mr
R2: *sc inc* [12]
R3: *1 sc, sc inc* [18]
R4: *2 sc, sc inc* [24]
R5: *3 sc, sc inc* [30]
R6: *4 sc, sc inc* [36]
R7: 36 sc back loop only [36]
R8: 36 sc [36]
R9: 36 sc back loop only [36]
R10: *4 sc, sc dec* [30]
R11: *3 sc, sc dec* [24]
R12: *1 sc, sc dec* [16]
R13: *sc dec* [8]
R14: *sc dec* [4]
Close.
NOTE: I'd recommend stopping at R11, sew on pieces and then finish the body.
With orange.
R1: 6 sc in mr
R2: *sc inc* [12]
R3: *1 sc, sc inc* [18]
R4: *2 sc, sc inc* [24]
R5: *3 sc, sc inc* [30]
R6: *4 sc, sc inc* [36]
R7: 36 sc back loop only [36]
R8: 36 sc [36]
R9: 36 sc back loop only [36]
R10: *4 sc, sc dec* [30]
R11: *3 sc, sc dec* [24]
R12: *1 sc, sc dec* [16]
R13: *sc dec* [8]
R14: *sc dec* [4]
Close.
ASSEMBLING:
Sew arms to sides of the body between R7-8 about the height of the lower part of the magic ring.
Sew legs between R7-8 on the bottom of the body, approximately three stitches apart from each other.
"MINUTES AND HOURS":
With black make four "lines" that are two rounds long in the "cardinal points" and a dot on the center of the magic ring of the body, with black embroidery floss make three lines in between each "cardinal point" that are one round long.
Sew arms to sides of the body between R7-8 about the height of the lower part of the magic ring.
Sew legs between R7-8 on the bottom of the body, approximately three stitches apart from each other.
"MINUTES AND HOURS":
With black make four "lines" that are two rounds long in the "cardinal points" and a dot on the center of the magic ring of the body, with black embroidery floss make three lines in between each "cardinal point" that are one round long.
FACE:
With white felt/ eva foam make a half moon for the smile that is about three rounds wide.
The eye should be four rounds tall and two rounds wide. With white felt/ eva foam make a slight curve for the lower part, on one of the sides also make a slight curve and on the other side make the curve a little more sharp. The side with the sharp curve goes toward the arms. Repeat for the other eye. With black felt/ eva foam make two ovals for the pupils around twenty percent smaller than the eyes, cut a small nick on the side to give them a cartoon look.
Glue mouth to R4 of the body.
Eyes will be glued on R1-4 of the body, the lower side of eyes falls at the height of the lower part of the magic ring, sew pupils to eyes with the nick toward the same side.
If having trouble making any of these, we can draw them on paper and once it's right we'll use it as a "mold", so we can place the mold on the felt or eva foam and cut around.
With white felt/ eva foam make a half moon for the smile that is about three rounds wide.
The eye should be four rounds tall and two rounds wide. With white felt/ eva foam make a slight curve for the lower part, on one of the sides also make a slight curve and on the other side make the curve a little more sharp. The side with the sharp curve goes toward the arms. Repeat for the other eye. With black felt/ eva foam make two ovals for the pupils around twenty percent smaller than the eyes, cut a small nick on the side to give them a cartoon look.
Glue mouth to R4 of the body.
Eyes will be glued on R1-4 of the body, the lower side of eyes falls at the height of the lower part of the magic ring, sew pupils to eyes with the nick toward the same side.
If having trouble making any of these, we can draw them on paper and once it's right we'll use it as a "mold", so we can place the mold on the felt or eva foam and cut around.
Miss Minutes is the perfect companion for Vote Loki & TVA Loki pattern which you can find here: http://hisheepok.blogspot.com/2021/06/vote-loki-loki-tva-2-in-1.html
How to crochet Miss Minutes on youtube:
Join me:
Instagram https://www.instagram.com/hisheepok
Pinterest https://pinterest.com/hisheepok
If you have any questions or thoughts do not hesitate to leave a comment.
This pattern is for personal use only. Please do not post this pattern to your website or blog, instead post a link to https://hisheepok.blogspot.com/2021/07/miss-minutes.html
If you post a photo of the amigurumi made with this pattern in the web I would appreciate it if you tag me, I'm @hisheepok, use the hashtag #hisheepok or put a link to my blog.
This pattern is for personal use only. Please do not post this pattern to your website or blog, instead post a link to https://hisheepok.blogspot.com/2021/07/miss-minutes.html
If you post a photo of the amigurumi made with this pattern in the web I would appreciate it if you tag me, I'm @hisheepok, use the hashtag #hisheepok or put a link to my blog.
This is great! I will try to make it :) thanks for sharing!
ReplyDeleteLove it, trying to learn to crochet so I can make it as my daughter loves Miss minutes. Not sure what you mean when you say in the back loop...
ReplyDeleteHi! When you are looking at the top of the stitch you should see two loops, you would usually grab them both when you insert your hook but here when I say the back loop I mean you should grab just the "second" loop, the one that is farthest from you. Hope this clears it :)
DeleteThanks, it does
ReplyDeleteI'm about to make this for myself and I am wondering what size hook you used?
ReplyDeleteHello! I used a 3 mm hook
Delete